Pics and Info
Photo 5 of 11
Previous Picture
72 Monte Carlo Home Page
Next Picture
Setting degree wheel to top dead center
The dial indicator was used to set the degree
wheel to 0º and was verified by using a piston stop.
The crank shaft was rotated both forward and
reverse and the degrees between when the piston
stopped before and after 0º should be an equal
distance from 0º.
The dial indicator was used to set the degree wheel to 0º and was verified by using a piston stop. The crank shaft was rotated both forward and
reverse and the degrees between when the piston stopped before and after 0º should be an equal distance from 0º. Setting degree wheel to top
dead center
Counter
Be a Sponsor!!
Shop at Amazon