|
|
|
|
 |
|
|
|
Holley and Weiand Team G Intake
|
|
|
|
The Holley is sitting on a Weiand Team G intake
with a power band of 3000 to 7500 RPM. The
intake was gasket matched and ported by my friend
Steve Gantz. He also knifed the vanes that
separate the intake runners. I gasket matched the
carburetor deck because about a quarter of an inch
protruded into the path of incoming air and fuel.
This would not have been a problem but there is a
two inch spacer under the Holley.
|
|
|
|
|
The Holley is sitting on a Weiand Team G intake with a power band of 3000 to 7500 RPM. The intake was gasket matched and ported by my
friend Steve Gantz. He also knifed the vanes that separate the intake runners. I gasket matched the carburetor deck because about a quarter of
an inch protruded into the path of incoming air and fuel. This would not have been a problem but there is a two inch spacer under the Holley.
Holley and Weiand Team G Intake
 |
|
|
Be a Sponsor!!
Shop at Amazon
|
|
|
|
|
|
|
|
